Chapter 4 Written Lab
Write the command or commands for the following questions.
What command is used to set a serial interface to provide
clocking to another router at 64k?
If you were to telnet into a
router and you get the response "connection refused, password not set,"
what would you do to stop receiving this message and not be prompted
for a password?
If you type show inter et
0 and notice the port is administratively down, what would you do?
If you wanted to delete the configuration
stored in NVRAM, what would you type?
If you wanted to set a user-mode
password for the console port, what would you type?
If you wanted to set the enable
secret password to cisco, what would you type?
If you wanted to see if a serial
interface needed to provide clocking, what command would you use?
What command would you use to
see the terminal history size?
What old Cisco command will change
a configuration stored on a TFTP host?
How would you set the name of
a router to Chicago?